HXE-450/13DL Aluminium rod breakdown machine
I. Quick details
HXE-450/13DL Aluminium rod breakdown machine is used to draw single
bare aluminium wire from 9.5mm to 1.7mm-4.2mm.The drawing capstans
are arranged in a line that are able to work continuously with
drawing speed and electrical control can be matched with each
II. Compositions of equipment
|1. Cantilever Pay-off shelf||1 set|
|2. HXE-450/13DL Main drawing machine||1 set|
|3. HXE-180 Tension controller||1 set|
|4. HXE-SX630 Double spoolers||1 set|
|5. Electrical cabinet||1 set|
|6. Operation panel||1 set|
|7. Gear Oil system (Pump+Cooler)||1 set|
|8. Spare parts||1 set|
III. Main technical parameters
|1. Inlet||9.5mm (Inlet wire straightening function is provided)|
|2. Outlet||1.7mm-4.2mm (Final wire cleaning function is provided)|
|3. Diameter of capstans||450mm|
|4. Speed||1500m/min, capacity say 1.7mm, 540kg per hour|
|5. Slip ratio||1.4-1.2 decrease|
|6. Quantity of capstan||13|
|7. Capstan||Tungsten carbide (With wire threading function)|
|8. Quick dies change||Available / Require less dies|
|9. Main motor||DC250KW, with DC Controller|
|10. Fix speed motor||DC75KW, with DC Controller|
|12. Noises of machine||≤85 db|
|13. Protection cover||Motor transmission cover installed|
|14. Others||Cooler for Gear oil is provided|
|15. Others||All main pipes are provided|
|16. Others Gear oil recycling complete system is provided,
including: Pump, Gear oil tank, Pipes, Oil Pressure Gauge, Signal
wire. When lack of oil, machine will auto stop.|
|17. Others Cooler for Lubrication oil , no need. You need prepare
one Underground Tank for Lubrication Oil recycle.|
IV. Machine maintenance and precautions
1. Make sure the machine and the capstans clean, no scrap, no break
2. Make sure the Take-up part clean.
3. Electrical cabinet should be closed.
4. Change belts if worn out.
5. Only qualified electrical technician can repair the electrical
6. Never change the Inverter parameter.
7. If something wrong with the machine that can`t solve, please
contact the supplier first.
Do not open the machine without talking to the supplier.
V. Common trouble solve method
1. After shut down the machine, need at least 30 seconds to restart
2. Wire often breaks, adjust the speed, balance arm, check the dies
are clean or not.
Before open the machine, make the balance arm at the lowest
position, and in running, the balance arm should be in the
horizontal line. No big shake, no up and down frequently.
3. If the wire sticks to the capstan, use Alcohol to clean the
4. Pay-off shelf doesn`t work well, change the position of the
5. Has nick on the wire, check the capstans on the Take-up part.
Check the drawing capstans.
When installation, make connect the ground wire.
When working, do not open the doors.
Do not touch the wire when annealing.
Regular check Coolant water, Steam, Compressed air.